NOTE:
If you select Full Scan, it takes a long time.
Auto Signal Booster:
Press or to select On or Off . If the receiving
signal is weak/strong and the picture is noisy,
the picture may be improved when using this
function.
3
Press to select Start Scan and press OK.
The television will start to search for all available
DTV and/or ATV services.
You must allow the television to complete
the search.
When the search is complete, the Auto Tuning
result screen will display the services found.
ATV Manual Tuning
1
From the SETUP menu, press or to select
ATV Manual Tuning.
2
Press OK to display the ATV Manual Tuning
menu.
Press or to select the programme position
you want to arrange.
Manual Tuning
Pos.
Label
0
1
ABCD
2
EFGH
3
IJKL
4
MNOP
5
6
7
3
Press OK to display the breakdown menu.
Press or to select an item, then press or
to select the item as shown below.
A. Position selection
B. System (Sound) ( - page 45)
C. Colour System ( - page 45)
A : Automatic (factory set), P : PAL,
S : SECAM, N4 : NTSC 4.43 (MHz),
N3 : NTSC 3.58 (MHz)
If the colour of a certain channel is abnormal,
the automatic colour system selection (A)
may have malfunctioned, or sound system
selection is wrong. In such a case, select
another colour and/or sound system ( -
page 45).
Introduction / Getting started
D. Position skip selection
Press or to turn the position skip option
on " 8 " or off " ( ". The position will then be
skipped when you select channels with P U
or P u . The " 8 " mark will appear beside a
position number when you use the Number
button on the remote control.
E. Signal Class
The channel classifi cation.
F. Channel
The channel number on which a station is
being broadcast.
G. Channel search operation
Press to search up the band or to search
down the band.
Press or repeatedly until your desired
channel is displayed.
When a station is found, it will be displayed.
NEVER PRESS ANY OTHER BUTTONS WHILE
THE SET IS TUNING.
H. Manual Fine Tuning
Press or until better picture and sound
are obtained.
I. Signal Booster
If the receiving signal is weak/strong and the
picture is noisy, the picture may be improved
when using this function.
Press the or to turn the Signal Booster
On or Off .
J. Label
Station labels appear under the programme
position display each time you turn on the TV,
select a channel, or press
To change or create station labels:
1) Press or repeatedly to select a
character for the fi rst space, then press
or .
2) Repeat step 1) to enter the rest of the
characters. If you would like a blank space
in the label name, you must choose a blank
space from the list of characters.
Press OK to store your settings.
.
(blank space)
15