Sub-Zero BI-36R Use & Care Manual page 14

Built-In Use & Care
Refrigerator Storage
STORAGE DRAWERS
To remove a storage drawer in the refrigerator section,
pull the drawer out until it stops. Lift the font of the drawer
slightly and pull the drawer straight forward. Refer to the
illustration below.
IMPORTANT NOTE: If the door is limited to a 0° door
opening, the shallow door shelves will need to be removed
from the bottom of the door in order to remove a drawer.
To reinstall, push the drawer slides back into the refrigera-
tor. Align the drawer with the slides, then push the drawer
straight back on to the slides until it stops. Press down-
ward on the front of the drawer to engage the slides.
DOOR SHELVES AND DAIRY COMPARTMENT
The door shelves and dairy compartment are adjustable
within the guides of the door liner. Glass door models do
not have door shelves or a dairy compartment.
To remove a shelf or the dairy compartment, lift it up and
out from the bottom. To reinstall, push it down into the
guides. Refer to the illustration below.
Storage drawer removal. Door shelf removal.
ADJUSTABLE GLASS SHELVES
Be sure to read the following instructions before removing
or adjusting shelves. To remove or adjust shelves, first tilt
the shelf up at the front, then lift it up and out of the tracks
on the rear wall of the refrigerator. Refer to the illustration
below.
If the door is limited to a 0° opening, you will need to
clear the door shelves in order to remove a shelf. Lift and
pivot the end of the shelf nearest the door upward, and
remove.
To replace a shelf, insert it in the tracks at the rear of the
refrigerator with the front of the shelf raised slightly. As
you push the shelf in, lower the front of the shelf until it
locks into position.
IMPORTANT NOTE: Use care when handling glass shelves
to prevent breaking the glass or scratching the interior.
Glass shelves should warm to room temperature before
immersing in warm water.
Glass shelf removal.
14