Removing And Replacing The Dvd-Ram Drive - IBM eserver 7210 Service Manual

5. Disconnect the power cable from the 7210 DVD-RAM Drive.
DANGER
6. Disconnect the SCSI bus cable from the 7210 DVD-RAM Drive.
7. Tilt the 7210 DVD-RAM Drive on its side and remove the four cover mounting
8. Remove the cover by sliding it to the rear (see the directional arrow in
To replace the cover, reverse this procedure.
Figure 6. Removing and Replacing the Cover. The 7210 DVD-RAM Drive is shown tilted on
its side.

Removing and Replacing the DVD-RAM Drive

To remove the DVD-RAM drive from the 7210 Model 025 DVD-RAM Drive:
1. Perform the cover removal procedure. Refer to "Removing and Replacing the
2. Disconnect the power supply connector (J1) ( 3 in Figure 7 on page 23) from
3. Disconnect the internal SCSI bus cable 2 from the DVD-RAM drive.
4. Disconnect the internal SCSI address cable 4 from the DVD-RAM drive.
5. Disconnect the audio jack plug 5 from the DVD-RAM drive.
6. Tilt the 7210 DVD-RAM Drive on its side (see Figure 7 on page 23). Support the
7. Support the drive while returning the 7210 DVD-RAM Drive to its original
8. Slide the DVD-RAM drive out the front of the chassis.
22
7210 DVD-RAM Drive Service Guide
To prevent a possible electrical shock from touching two surfaces with
different electrical grounds, use one hand, when possible, to connect or
disconnect signal cables. (RSFTD004)
screws from the bottom. See Figure 6.
Figure 6).
Cover" on page 21.
the DVD-RAM drive 6 .
DVD-RAM drive while removing the four screws 1 that secure the drive to
the chassis.
position.