Table of Contents
Advertisement
Step 17
This step verifies whether the 7210 DVD-RAM Drive can communicate with the
host system.
1. At the command line on any AS/400 or iSeries menu, type
2. At the System Service Tools (SST) screen, type 1 (Start a service tool), then
3. At the Start a Service Tool screen, type 7 (Hardware service manager), then
4. At the Hardware Service Manager screen, type 2 (Logical hardware resources),
5. At the Logical Hardware Resources screen, type 1 (System bus resources), then
6. In the Description column of the Logical Hardware Resources on System Bus
7. At the Select IOP Debug Function screen, type 4 (IPL I/O processor), then press
8. After the IPL completes, press F12 to return to the Logical Hardware Resources
9. In the Description and Type-Model fields of the Logical Hardware Resources on
The Logical Hardware Resources Associated with IOP screen displays with a list of
devices that are configured to the SCSI controller. The 6330 device and its optical
controller appear in the list and display a status of Operational.
Is the device and a controller listed under the Storage IOP column, and is their
status operational?
NO
YES
18
7210 DVD-RAM Drive Service Guide
strsst
then press Enter.
press Enter.
press Enter.
then press Enter.
press Enter.
screen, locate the input/output processor (IOP) device (the SCSI controller) to
which the 7210 DVD-RAM Drive is attached. Type 6 (I/O Debug), then press
Enter (refer to "Performing the Checkout Procedure" in the 7210 Model 025
DVD-RAM Drive Setup and Operator Guide).
Enter twice. The host performs an initial program load (IPL), refreshes its
settings, and displays the message Re-IPL of IOP was successful .
Note: Performing an IPL (option 4) for the IOP also resets any other IOA
adapters connect to the host system.
on System Bus screen.
System Bus screen, locate the IOP storage device (the SCSI controller) to which
the 7210 DVD-RAM Drive is attached. Type 9 (Resources associated with IOP),
then press Enter.
Contact your next level of support for further instructions.
Exit the System Service Tool to a command line, then continue
with Step 18.
Advertisement
Table of Contents
