Error Code
Description
E4E
Under volts after
start
E4F
EEProm fault
E52
Main control
wake-up error
E53
Buffer error
E54
No motor
response
E57
Checksum failure Software
E58
Communication
failure
E60
Door lock switch
failure
Problem
Initial minimum
•
Check Motor - t10 tumble, t11 spin, t14 spin.
voltage not
•
Power down (unplug) washer, wait 30 seconds and
received
retry - if reoccurs, replace inverter. (Note: Cannot
- motor does
occur with open winding.)
not run. DC bus
(inverter).
EEProm reading
•
Non-recoverable error.
error occurs.
•
Replace inverter control board.
Lost
•
Check Motor - t10 tumble, t11 spin, t14 spin.
communication
•
Check connections/cables between main control
between
and inverter.
control and
drive motor
•
Power down (unplug) washer, wait 30 seconds and
after initial
retry - if reoccurs, replace inverter. (Note: Cannot
success.
occur with open winding.)
•
Main control board can cause code in limited
circumstances, as loose plug on board.
Internal
•
Check Motor - t10 tumble, t11 spin, t14 spin.
software buffer
•
Power down (unplug) washer, wait 30 seconds and
error.
retry - if reoccurs, replace inverter. (Note: Cannot
occur with open winding.)
Lost
•
Check Motor - t10 tumble, t11 spin, t14 spin.
communication
•
Check connections/cables between controls.
between
control and
•
Power down (unplug) washer, wait 30 seconds and
drive motor.
retry - if reoccurs, replace inverter.
•
Non-recoverable error.
error occurs
•
Main control board must be replaced.
- checksum
failure.
Communication
•
Non-recoverable error.
error occurs.
•
Main control board must be replaced.
Switch failure
•
Power down (unplug) machine, wait 30 seconds and
occurs during
retry.
lock.
•
Check wiring and connections between door lock
and main control.
•
Check door lock switches and solenoid.
•
Replace main control if wiring, switches, and
solenoid test functional.
– 55 –
Possible Cause/Action
(Continued Next Page)