GE WBVH6240 Technical Service Manual page 17

6. Set the dryer upright using packing material or a
protective surface that ensures the brackets do
not damage the fl oor.
7. Place and level the washer in the approximate
location. (Refer to washer installation
instructions for details.)
8. Remove the 3 Phillips-head screws that attach
the top cover, then pull the cover rearward.
Caution: Protect the washer control panel with
cardboard or other protection to prevent damage
caused by contact with the dryer brackets.
9. Lift the dryer high enough to clear the washer
control panel and place the dryer on top of the
washer.
10. Align the holes in the brackets with the holes
in the back of the washer. Attach the brackets
to the washer using 4 (#8 x ½-in.) Phillips-head
screws.
WARNING!
Do not push on the dryer after it is stacked on the
washer. Pushing on the dryer may result in pinched
fi ngers.
Caution: Use felt pads or other sliding device to
assist moving and to protect fl ooring.
Note: Ensure that the washer and the dryer are
in compliance with their respective installation
instructions.
11. Carefully slide or walk the stacked washer and
dryer into place.
Place hands here
– 17 –
Place hands here