Ordering.procedures - Falcon MA Series Service Manual

MA-Series Service Manual

Ordering.Procedures

How to Order
For correct ordering, and to ensure no delays in shipment of
your order, the following descriptive data must be listed in the
sequence shown. Necessary information can be found in other
parts of this manual. The example below shows an order for 16
each MA locksets in the 521 Entry function, DG (Dane-Gala) trim
design in a 626 (satin chrome) finish, 8 RH (right hand) and 8
LH (left hand) to accommodate doors 1³⁄₄" thick with AA1-AA16
keying.
Quantity: Indicate the quantity required.
Catalog Number: Select catalog number.
Trim Design: Indicate letter of knob or lever design followed by
letter of rose or escutcheon design.
Example: DG-D for Dane lever followed by G for Gala rose.
Finish: When the finish is the same for the outside and inside
trim, it is shown once (626). For split finishes, the outside is
designated first, then the inside (626 x 625).
Latch: Two-piece mechanical anti-friction standard. All catalog
How to Order Example
Catalog Trim
Qty.
Number Design
8 MA521P DG
8 MA521P DG
Finishes
Falcon offers several finish choices to compliment the
design elements of most any project. Falcon applies the
best available protective plating or coating to the surface of
our products to minimize the exposure to weather, pollution,
perspiration, extremes of climate, frequency of us and other
Trim Finishes Chart
Description ANSI No.
Bright Brass 605
Satin Brass 606
Satin Bronze Oil 613
Rubbed
Bright Chrome 625
Satin Chrome 626
Satin Stainless Steel 630
Finish Latch Strike Cylinder
626 STD STD 6-PIN
626 STD STD 6-PIN
Available on
US 3 All Trim
US 4 All Trim
US 10B All Trim
US 26 All Trim
US 26D All Trim
US 32D All Trim
numbers shown in this manual indicated 2³⁄₄" backset.
Strike: 4⁷⁄₈" x 1¹⁄₄" x 1¹⁄₄" lip-to-center with curved lip standard.
Optional strikes with shorter or longer lip lengths available.
Cylinder Type: For 6-Pin, add 6-Pin. For 7-Pin, add 7-Pin.
Door Hand: See chart.
Keying Detail: We suggest using the standard terms developed
by the A.H.C. (Consult Factory).
Example: AA1 - Grand Master keyed, Master keyed, change key 1.
Interchangeable Core: To order product capable of accepting
an interchangeable core, add "B" less SFIC (for interchangeable
core). To order product with an interchangeable core, add "SFIC"
(with interchangeable core). Ex: "G" with Falcon SFIC core.
Keyway: "G" is standard on regular cylinders, "A" is standard on
interchangeable cores. Other keyways available. See price book.
Additional Keys: Note the total number of keys required.
Large Bow Keys: Add - "with large bow keys".
Door Hand
RH LH RHR LHR Detail
X
X
factors. Please consult with us if your building is subjected to
chemical or corrosive conditions, as some finishes would not
be recommended for these areas. Falcon recommends chrome
plated or stainless steel finishes for high corrosive environments.
How to Determine the Hand of a Door
Mortise Cylinders
AA1-AA8 1-3/4" DR
AA9-AA16 1-3/4" DR
43