Installation & Placement - LD Stinger 8A User Manual

INTRODUCTION
The STINGER series was designed in response to customer demands for high-quality multi-functional speakers. They
are equipped with selected components; feature a custom crossover and a very complete protection circuit.
MOUNTING OF THE FLYWARE COMPONENTS
The STINGER 12(A)/15(A) are designed to allow the mounting of the Adam Hall 5720 flyware components. To mount
these components on the speaker first remove the flyware covers ("BMS Inside" and "Powered by Eminence" ban-
ners). With the passing mounting screws you can install the Flyware rails (5720) in the pre-drilled cutouts. We also
recommend the use of back plates on the inner side of the speaker. In order to fit those back plates (like the 5730) on
the speaker box you must unscrew the front grid and build out the woofer.
Security advice: Adam Hall assumes no liability for the mounting of flyware components!
APPLICATION NOTICE FOR SM707 ADjUSTABLE STANd RECEPTACLE
STINGER 12/15 PASSIvE ANd ACTIvE:
The built-in, patented SM707 adjustable speaker stand receptacle offers unparalleled possibilities for adjustment +/-
16° in 4° increments. To do this, simply lift the cabinet slightly on the speaker stand, causing the set angle to loosen,
and lower the cabinet on the stand again to cause it to engage at the desired angle (see drawing).
Centre of Rotation
+/- 16°
INSTALLATION & PLACEMENT:
Lift cabinet
Attention! Please hold the
cabinet firmly!
Turn the cabinet into the
required angle.
Lower the cabinet.
5