Assembly; Fitting The Handlebar; Transport Position, Handlebar - Husqvarna 235F Operator's Manual

Fitting the handlebar

• Remove the screw at the rear of the throttle handle.
• Slide the throttle handle onto the right side of the
handlebar, (see diagram).
• Align the screw hole in the throttle handle with the hole
in the handlebar.
• Refit the screw in the hole in the rear of the throttle
handle.
• Screw the screw through the handle and handlebar.
Tighten it.
• Remove the mounting components from the
handlebar mounting.
• Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.

ASSEMBLY

• Fit the wiring as shown.
• Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness. Tighten the knob.

Transport position, handlebar

• The handlebar can easily be turned to fit along the
shaft for easier transportation and storage.
• Loosen the knob. Turn the handlebar clockwise so that
the throttle handle rests against the engine.
• Now twist the handlebar around the shaft. Tighten the
knob.
• Fit the transport guard to the cutting attachment.
–
English 13