Advertisement
Genlock Input
A single DIN 1.0/2.3 coaxial connector accepts a Tri-Level Sync signal for video genlocking.
When operating at 23.98, 24.00, 25.00 or 29.97 Project Time Bases, set the genlock signal gen-
erator to SMPTE 274 progressive scan format, at the same frame rate as the project TIME BASE.
Do not use PsF or interlaced signals.
Using an Ambient ACL202CT, set dip switches as follows: D = down, U = up, R = right, L = left
Note: After changing any of the above dip switch settings, power cycle the ACL202CT unit.
Frame Rate
23.98 fps
24.00 fps
25.00 fps
29.97 fps
When operating at 50.00 or 59.94 Project Time Bases, set the genlock signal generator to
SMPTE 296 progressive scan format, at the same frame rate as the project TIME BASE.
Using an Ambient ACL202CT, set dip switches as follows: D= down, U = up, R = right, L = left
Frame Rate
50.00 fps
59.94 fps
Connect the camera Genlock input to the ACL202CT VIDEO/WORD output using a BNC cable.
Pin:
Center
Shield/Screen
Program (Dual-link) HD-SDI
Two DIN 1.0/2.3 connectors labeled HD-SDI support progressive scan HD Program signals.
Pin:
Center
Shield/Screen
72
1D, 2U, 3D, 4D, 5U, 6U, 7U, AR, BR
1D, 2U, 3U, 4D, 5U, 6U, 7U, AR, BR
1U, 2U, 3U, 4D, 5U, 6U, 7U, AR, BR
1D, 2D, 3U, 4D, 5U, 6U, 7U, AR, BR
- settings not verified at this time -
1D, 2D, 3U, 4U, 5U, 6D, 7U, AR, BR
Signal
SMPTE 274M-2005 Tri-level Sync
GENLOCK
GROUND
Camera ground
Genlock Input Signal
Signal
HD-SDI
SMPTE-292M HD-SDI
GROUND
Camera ground
Program HD-SDI Output (each connector)
Copyright RED Digital Cinema
Description
Description
Direction
In
--
Direction
Out
--
Nov 27 2008
Advertisement
