Husky HU80522 Operator's Manual page 11

ASSEMBLING THE SPRAY WAND
See Figure 5.
To attach the spray wand extension:
 Place the threaded end of the wand extension in the
connector on the end of the spray wand assembly.
 Turn the connector clockwise until it stops. This
the wand extension in place.
 When not in use, remove the spray wand extension from
the spray wand by turning the connector counter clock-
wise. Store both pieces on top of the pressure washer.
CONNECTING HIGH PRESSURE HOSE TO
SPRAY WAND ASSEMBLY
See Figure 6.
 Screw the collar on the high pressure hose into the spray
wand's inlet coupler by turning the hose collar clock-
wise.
Pull on the hose to be certain it is properly secured.

ASSEMBLY
secures
HIGH PRESSURE
HOSE
11
SPRAY
WAND
GROOVED
GRIPPING
SURFACE
CONNECTOR
SPRAY
WAND
EXTENSION
COLLAR
Fig. 5
INLET
COUPLER
Fig. 6