Receiving The Saw; Installation And Assembly - Powermatic 66 Instruction Manual & Parts List

RECEIVING THE SAW

Open shipping container and all separate cartons con-
taining rails and accessories. Report any damage
immediately to your distributor. Read the instruction
manual thoroughly for assembly, alignment, mainte-
nance and safety instructions.
Box contents:
Box 1: table saw, extension wings, mitre gauge,
manual
Box 2: splitter and guard assembly, splitter support
shaft, arbor wrench, hardware bag*
Box 3: Accu-Fence, lock handle, manual
Box 4: Front & rear rails, guide tube, hardware bag
Box 5: Motor cover & two self-tapping screws
Optional:
Box 6: Formica top extension table
Box 7: Legs for extension table
*The contents of the hardware bag are drawn full scale
in Figure 1. (The contents of the fence & rail hard-
ware can be found in the Accu-Fence manual)

INSTALLATION AND ASSEMBLY

Tools required
7/16, 9/16, 3/8 and 1/2 wrenches
1/8 and 3/32 hex wrenches
Flat head screwdriver
Hammer & wood block (or rubber hammer)
1. Remove box and wood crating from around saw.
2. With a 9/16" wrench, remove the carriage bolt
holding the extension wings together and set wings
aside for later installation.
3. With a 7/16" wrench, remove the lag screws
holding the saw to the wooden skid. Carefully slide
the saw from the pallet onto the floor.
4. Tilt the saw, and pop off the metal tabs that se-
cured the saw to the skid, by pushing down on them.
NOTE: Exposed metal parts such as the top and ex-
tension wings have been given a protective coating
at the factory. This should be removed with a soft
cloth and solvent (such as mineral spirits) once the
machine has been assembled. Do not use an abra-
sive pad.
8
Hex Head Screw
3/8-16 x 1
Qty. 6
Lock Washer
3/8
Qty. 6
FIGURE 1