Labconco SteamScrubber 44003 Series User Manual page 48

Chapter 6: Modifying Your Washer
8. Plug the supplied harness into terminal J6 on the Relay PCB and route the
other end to the left rear corner of the washer base.
9. Plug the wire from the detergent container to the mating connector in the new
harness in the base of the washer.
10. Plug the connectors on the pump to the mating connectors in the new harness
in the base of the washer.
11. Reinstall the junction box cover and lower panel.
12. Reinstall the back panel if the washer is a Freestanding model.
13. Turn on the electrical power.
Enable the liquid detergent dispenser operation:
1. Enter the washer set up screen on the display by holding the
control panel and closing the door and sliding the door latch to the right.
2. Press the button until the arrow on the left points to LIQ DETERGENT OPT.
3. Press the or
4. Press RUN to save all settings.
Using the liquid detergent dispenser:
1. Remove the cap from the container and remove the tube and level switch assembly.
2. Fill the container with detergent or use a new bottle of Labconco detergent
and replace the tube and switch assembly and the cap.
3. There are two methods which can be followed for filling the system with detergent.
a. Run a wash cycle with no glassware in the washer. Set the
detergent dispense rate to 30 ml.
b. Run a diagnostics test. When the display window shows
DETERGENT PUMP, allow the pump to run for 30 seconds.
4. Program the quantity of detergent that will be dispensed by entering the
programming screen as described in Chapter 4: Using Your Washer.
44
button to activate this accessory.
Product Service 1-800-522-7658
button on the