Inner Flange; Lock Nut; Lock Nut Wrench; Depressed Center Grinding Wheel/Multi-Disc - Makita 9564PC Instruction Manual

For tool with locking screw type wheel guard
1
2
008374
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box.
Then rotate the wheel guard around 180 degrees
counterclockwise. Be sure to tighten the screw securely.
To remove wheel guard, follow the installation procedure
in reverse.
For tool with clamp lever type wheel guard
1
2
008375
1
008376
Pull the lever in the direction of the arrow after loosening
the screw. Mount the wheel guard with the protrusion on
the wheel guard band aligned with the notch on the
bearing box. Then rotate the wheel guard around 180°.
Fasten it with the screw after pulling lever in the direction
of the arrow for the working purpose. The setting angle
of the wheel guard can be adjusted with the lever.
To remove wheel guard, follow the installation procedure
in reverse.
Installing or removing depressed center
grinding wheel/Multi-disc (accessory)
Mount the inner flange onto the spindle. Fit the
wheel/disc on the inner flange and screw the lock nut
onto the spindle.
1. Wheel guard
2. Bearing box
3. Screw
3
1. Wheel guard
2. Bearing box
3
3. Screw
4. Lever
4
1. Screw
1
2
3
008377
To tighten the lock nut, press the shaft lock firmly so that
the spindle cannot revolve, then use the lock nut wrench
and securely tighten clockwise.To remove the wheel,
follow the installation procedure in reverse.
1
2
008378
To remove the wheel, follow the installation procedure in
reverse.
Installing or removing flex wheel (accessory)
1
2
3
4
008382
WARNING:
Always use supplied guard when flex wheel is on
•
tool. Wheel can scatter during use and guard helps
to reduce chances of personal injury.
Follow instructions for depressed center grinding
wheel/Multi-disc but also use plastic pad over wheel.
See order of assembly on accessories page in this
manual.
6

1. Lock nut

2. Depressed
center grinding
wheel/Multi-disc

3. Inner flange

1. Lock nut wrench

2. Shaft lock
1. Lock nut
2. Flex wheel
3. Plastic pad
4. Inner flange