Wheel Guard; Inner Flange; Depressed Center Grinding Wheel/Multi-Disc 5 Lock Nut; Lock Nut - Makita 9016DB Instruction Manual

1. Wheel guard

2. Bearing box
3. Screw
1
2
3

1. Lock nut

2. Depressed center grinding wheel/
Multi-disc

3. Inner flange

2
1. Lock nut wrench
2. Shaft lock
Installing or removing wheel guard
001063
CAUTION:
• When using a depressed center grinding wheel/Multi-
1
disc, wire wheel brush or cut-off wheel, the wheel guard
3
must be fitted on the tool so that the closed side of the
guard always points toward the operator.
2
Mount the wheel guard with the protrusion on the wheel
guard band aligned with the notch on the bearing box. Then
rotate the wheel guard around 180 degrees. Be sure to
tighten the screw securely.
To remove wheel guard, follow the installation procedure in
reverse.
Installing or removing depressed center grinding
001075
wheel/Multi-disc
WARNING:
• Always use supplied guard when depressed center
grinding wheel/Multi-disc is on tool. Wheel can shatter
during use and guard helps to reduce chances of
personal injury.
Mount the inner flange onto the spindle. Fit the wheel/disc on
the inner flange and screw the lock nut onto the spindle.
To tighten the lock nut, press the shaft lock firmly so that the
001088
spindle cannot revolve, then use the lock nut wrench and
1 securely tighten clockwise.
To remove the wheel, follow the installation procedure in
reverse.
7