Connecting The Wires - Hunter 42710-01 Installation And Operation Manual

InSTAllInG THE THErMOSTAT, COnT.
1. loosen, but do not remove, the terminal screws.
Jumper
note: A jumper wire has been provided, connecting the
rC and rH terminals for systems that do not provide both
an rH and rC wire. If you have both an rH and rC wire,
G RC RH Y W
remove this jumper. If you do not have both an rH and rC
wire, leave the jumper in place.
2. Match and connect the wires from the wall to the
terminals as shown. Wires should be inserted behind the black
terminal shields. Tighten each screw after the connection has
been made.
(The ends of any extra wires should be individually wrapped in electrical
tape and carefully pushed back into the wall.)
3. Push any excess wire length back into the wall to prevent
interference.

COnnECTInG THE WIrES

17