Table of Contents
Advertisement
Available languages
Available languages
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be
cleaned with a soft damp cloth. NEVER use solvents to clean plastic parts. They could
possibly dissolve or otherwise damage the material.
Wear ANSI Z87.1 safety glasses while using compressed air.
FAILURE TO START
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for the life of
the unit under normal operating conditions. No further lubrication is necessary.
BRUSH INSPECTION
For your continued safety and electrical protection, brush inspection and replacement
on this tool should ONLY be performed by an AUTHORIZED PORTER-CABLE SERVICE
STATION or a PORTER-CABLE•DELTA FACTORY SERVICE CENTER.
At approximately 100 hours of use, take or send your tool to your nearest authorized Porter-
Cable Service Station to be thoroughly cleaned and inspected. Have worn parts replaced
and lubricated with fresh lubricant. Have new brushes installed, and test the tool for
performance.
Any loss of power before the above maintenance check may indicate the need for immediate
servicing of your tool. DO NOT CONTINUE TO OPERATE TOOL UNDER THIS CONDITION.
If proper operating voltage is present, return your tool to the service station for immediate
service.
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our website at
servicenet.porter-cable.com. You can also order parts from your nearest factory-owned
branch, or by calling our Customer Care Center at 1-888-848-5175 to receive personalized
support from highly-trained technicians.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For
information about Porter-Cable, its factory-owned branches, or an Authorized Warranty
Service Center, visit our website at www.porter-cable. com or call our Customer Care
Center at 1-888-848-5175. All repairs made by our service centers are fully guaranteed
against defective material and workmanship. We cannot guarantee repairs made or
attempted by others.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North,
Jackson, Tennessee 38305 - Attention: Product Service. Be sure to include all of the
information shown on the nameplate of your tool (model number, type, serial number, etc.).
MAINTENANCE
(If applicable)
SERVICE
16
Advertisement
Table of Contents
