Troubleshooting Table wobbles. 1. Remove all objects from the table. Carefully lift the fan to ensure all three feet are properly installed. 2. Check that the notches in the table are sitting properly on the pin. 3. Tighten all screws.
Page 3
Your new accessory Hunter table can be installed at one of three heights: bar height standard table height lounge height 44.5” 31.5” (113 cm) 23” (80 cm) (58 cm) *shown with optional accessory light kit (not included) Step 1 Note: Be sure to hold the power cord out of the way of the bolt.
Page 4
2. Attach the upper adapter to the table with six adapter screws with washers. Thread the lower adapter into the upper adapter and rotate one to two turns. Note: The lower adapter should not be over-tightened. It should remain loose in the upper adapter to properly attach to the table.