Hunter 9016x Owner's Manual page 10

21. Slide the Blade assembly Sleeve
over the Motor Shaft, ensuring
the Blade assembly Screw is po-
sitioned over the Flat portion of
the Motor Shaft. See Figure 9.
Tighten the Blade assembly Set-
screw so that it seats against the
Flat portion of the Motor Shaft.
gently pull the Blade assembly
to ensure it is secure on the Mo-
tor Shaft.
FIGurE 9
NoTE: For clarity, the Back Grille
and Interlock Bracket have been
removed from Figure 9 to show the
Blade assembly Sleeve/Motor Shaft
installation.
10
22. with the Hunter logo facing for-
ward and upright, engage the
tabs on the lower part of the
Front Grille into the rim of the
Back Grille, as shown in Figure
10, arrow 1. Then, move the
top of the Front Grille as shown
in Figure 10, arrow 2, so that
the tab at the top of the Front
Grille snaps under the rim of the
Back Grille.
2
1
FIGurE 10
23. align the two ends of the Inter-
lock Bracket with the two notches
in the tab on top of the Front
Grille. press the two ends of the
Interlock Bracket into the two
notches of the tab on the top of
the Front Grille. See Figure 11.
FIGurE 11
42733-01 04/26/2007