Table of Contents
Advertisement
Using Your Remote Control
Arming the Security System
To arm the system, exit the vehicle, close all doors, then press the
parking lights will flash 2 times, indicating the system is armed, has locked the
doors (if equipped and connected) and activated the starter disable feature. The
LED status indicator will blink steadily, once per second.
NOTE: The system is equipped with a feature called Silent Choice. If enabled, the
system requires a second press of the
response from the vehicle.
Bypassing The Shock Sensor
To arm the system and ignore the shock sensor press
seconds press
NOTE: The system will only change the shock sensor setting for one arm cycle
and will be defaulted back to normal operation the next time the system is armed.
Disarming the Security System
To disarm the system press the
indicating the system is disarmed and has unlocked the doors (if equipped and
connected).
NOTE: The system is equipped with a feature called Silent Choice. If enabled, the
system requires a second press of the
response from the vehicle. If your system is set up for 2 step unlock, a third press
of unlock will activate the audible response.
Two Stage Door Unlock (Optional)
If this feature is enabled on your system, pressing the
unlock only the driver's door. Press
remaining doors.
Activating the Trunk Release Feature (Optional)
If this feature is enabled on your system, pressing and holding the
seconds will open the vehicle's trunk or hatch.
*Throughout this manual, 'press' refers to pressing for less than 1 second; 'press and hold' refers to pressing for more
than 2 seconds.
ca1151 rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
+
, the system will respond with 1 long chirp.
button. The parking lights will flash 1 time,
button to activate an audible arming
button to activate an audible disarming
again within 5 seconds to unlock the
button. The
button, then within 5
button one time will
button for 3
3
Advertisement
Table of Contents
