Table of Contents
Advertisement
8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
fi rebox.
B. Leg Leveling System
Figure 8.1
Thread Allen bolts through nuts until fl ush. The
Allen bolts and nuts are included in the component pack inside
the appliance fi rebox.
Figure 8.2
Slide assembled nuts and bolts into the slots on
the legs with the nuts on the bottom.
Figure 8.3
Use a 5/32 in. 4mm) Allen wrench to adjust legs
up and down to desired level.
C. Flue Restrictor Installation
When your installation falls within a shaded area on the
vent graph (page 11) a fl ue restrictor must be installed
for proper operation.
Figure 8.4
removal of the baffl e located inside the fi rebox. Remove the
baffl e by fi rst removing the two screws holding the baffl e in
place (one on each side). Lift the baffl e out of the bracket
along the back of the fi rebox, angle the baffl e slightly and
remove it from the fi rebox.
Figure 8.5
located in the back of the fi rebox. Reuse the screws to install
the fl ue restrictor.
Quadra-Fire • GARNET-T • 7016-127 Rev. i • 12/11
Installation of the fl ue restrictor requires the
With the baffl e removed, remove the two screws
Page 31
Hide quick links:
Advertisement
Table of Contents
