Existing Masonry Chimney - Quadra-Fire GARNET-MBK Owner's Manual

4. Existing Masonry Chimney

Type A & B - Co-Axial to Co-Linear
Type A
Co-Axial to
Co-Linear
Connector
Pipe Length
Optional
Type B
Co-Axial to
Co-Linear
Connector
Pipe Length
Optional
Figure 5.24
Page 20
Chimney Liner
Termination Cap
3 in. (76mm)
Flex Liner
Showing two 35 ft.
(11m) Sections of
Flex Liner
Chimney Liner
Termination Cap
25 ft. (8m) of 3 in.
(76mm) Flex Liner
Exhaust Section
This section of the
chimney must be
sealed
The chimney must be sealed from
the 4 ft. (1m) section
termination using a smoke shelf
or a damper. The seal should be
6 in. (152mm) below the end of
the 4 ft. (1m) Air Intake section.
4 ft. (1m) of 3 in.
(76mm) Flex Liner
Air Intake Section"
Quadra-Fire • GARNET-T • 7016-127 Rev. i • 12/11
Type C - Up & Out Installation
TOP ADAPTOR
CONNECTOR
90° ELBOW
DIRECT
VENT PIPE
Type D - Hearth Mount
Alcove Clearance to
Combustibles must
be maintained.
to
*In the Commonwealth of Massachusetts, the word damper
shall be replaced with the words fl ue restrictor.
TERMINATION CAP
FLASHING
4 in. (102mm)
RETRO
FLEX LINER
Chimney Liner
Termination Cap
25 ft. (8m) of 3 in.
(76mm) Flex Liner
Exhaust Section
This section of the
chimney must be sealed
Chimney must be sealed
from 4 ft. (1m) section to
termination using a smoke
shelf or a damper*. Seal
should be 6 in. (152mm)
below end of 4 ft. (1m) Air
Intake section.
4 ft. (1m) of 3 in. (102mm)
Flex Liner
Air Intake Section"
Co-Axial to Co-Linear Connector