Centurion Spas CT 10000 Owner's Manual page 31

CODE DESCRIPTION
SP Ot Internal
overheat
Low-Level Settings
The spa pack – located inside the spa below the
topside control panel – has a service panel used to
set your spa's low-level programming options. During
troubleshooting, you may need to check or reset these settings.
Resetting the Spa Pack – To reset the spa pack, press the Select
button twice.
Breaker current setting – To adjust the breaker current setting (Br),
press the Select button and then press the Change button. The
normal current settings are:
Low-level setting – To reset
the low-level setting (LL),
press and hold down the
Select button for 5
seconds. Use the Change
button to set LL=01 (even
if the present value is 01).
Press Select to save.
• Open the access panel to the spa pack
(below the control panel) and allow
two hours to cool down
• Reset GFCI breaker
For 240V 60Hz spas: Br = 40
For 240V 50Hz 1φ spas: Br = 1P
For 240V 50Hz 2φ spas: Br = 2P
For 240V 50Hz 3φ spas: Br = 3P
Heater 1
CORRECTIVE ACTION
Light
Select
Change
Pump 1
29
Heater 2
Topside
Ozonator
Pump 2
Blower