Centurion Spas CT 10000 Owner's Manual page 20

6. Press the Pump 1 button a third time to turn Pump 1 off. A built-
in timer automatically turns Pump 1 off after 20 minutes, unless
the pump manually has been deactivated first.
7. Press the Pump 2 button to activate the single-speed pump (if
equipped). If Pump 2 has not primed after 2 minutes repeat
same priming procedure of step 3 above for Pump 2. Check
and adjust the water and airflow of every jet from Pump 2 if
necessary.
8. Press the Pump 2 button a second time to turn off Pump 2.
9. Press the Blower button to turn on the air blower (if equipped).
Check if air goes to air jets on the butt/bottom of each seat.
10. Press the Blower button again to turn the Blower off. A built-in
timer automatically turns the Blower off after 20 minutes, unless
it manually has been deactivated first.
11. Press the Light button to turn the spa Light on. Verify the spa
Light is on.
12. Press the Light button a second time to turn the spa Light off. A
built-in timer automatically turns the spa Light off after two
hours, unless the spa Light manually has been deactivated first.
Step-by-step Programming
Note: During programming, the heater is disabled and its icon
flashes.
Note: Use Filter Cycle times that are different from your normal
bathing times.
1. Use the Up/Down button to set the desired water temperature
(102°F recommended).
2. Press and hold down the Light button for five seconds to
access the time-of-day and filter-cycle programming menus.
18