Advertisement
warning: Blade is extremely sharp! Keep fingers away from the cutting path of the blade. always wear eye
protection while using this or any other table saw.
B. Blade sharpening and replacement
after extended use, the blade may become worn or dull. a dull blade is detectable by a slower cutting speed or if
the material is left with a jagged or irregular edge. Blade re-sharpening services are available in many communities,
and can be located through a phone directory or your local hardware store. Replace a dull or worn blade with a new
blade for optimal cutting performance.
troubleshooting
problem: work material becomes jammed.
Cause: Dull blade.
solution: Before freeing any jammed materials, turn oFF Power Switch, wait until all moving parts have stopped
and unplug from outlet. Gently rock back and forth to free work materials. inspect blade to be sure teeth are not
bent or broken.
problem: Saw runs slowly or stops while cutting
Cause: Blade is "gummed-up" due to soft materials or tape.
solution: Before cleaning blade, turn oFF power switch and wait until all moving parts have stopped. Unplug from
outlet and clean blade surface.
replacement Parts
Item
PLexi-GLaSS GUaRD
anGLe GUiDe
TaBLe
on/oFF SwiTch
BLaDe GUaRD
moToR 11oV
moToR 220V
4" BLaDe
Page 4 - PowerMiter iv instruction Manual
Item Number
#P605
#P608
#P613
#P618
#P620
#P629
#P629a
#78
Advertisement
