Rear Terminals; Helpful Hints; Connecting Other Equipment; Specifications - Sanyo CE15LC4-B Instruction Manual

Rear T erminals

Connecting other equipment

You can connect a VCR, S-VHS VCR, Satellite Tuner, PAY TV Decoder, DVD
or Camcoder to this TV via the SCART terminal and the RCA terminals.
This TV set has the following rear terminals:
- AV1: scart which has RGB and composite video signal inputs and TV
output.
- AV2: RCA Audio/video input.
Depending on the type of video tape or connected AV equipment being
used, it may be necessary to select colour system. In this case, press
the Recall/System button and select a suitable colour system. Colour
system setting for AV position is automatically stored in the memory.
Connect the VCR or DVD right and left audio output to the correspon-
ding left (l) and right (r) input channels. By pressing the Stereo/Mono
button repeatedly, you can select the sound track L (left), R (right) or
L/R.
You can select and return to a TV programme by selecting any of the TV
position while watching a playback from a VCR, DVD, etc.
By pressing the button on your remote control you can change
the source of the input signal. The sequence is the following:
TV mode AV1 AV2

Helpful Hints

NO PICTURE, NO SOUND
Check if TV is plugged in.
Try a different channel, if OK, probably station trouble.
Try to switch on the TV pressing the red stand-by key from the remote
control.
POOR PICTURE, SOUND OK
Adjust BRIGHTNESS, CONTRAST control.
Adjust FINE TUNING control.
Check aerial connections.
NO COLOUR, PICTURE OK
Adjust COLOUR control.
Adjust FINE TUNING control.
Is the programme in colour?
WEAK PICTURE
Check aerial connections on back of set.
Check aerial for broken wires.
Re-orient aerial.
POOR SOUND QUALITY
Check the sound system in "Preset menu".
The following faults are not caused by the receiver:
"GHOSTS"
Reflections of signals from mountains or high buildings will cause multiple
images, called "Ghosts". These abnormal conditions can be reduced to
minimum by repositioning aerial or by installing a new one suited for your
area.
"INTERFERENCE"
Interference may be caused by electrical appliances, car ignition systems,
etc. This should normally be a temporary condition, but should this inter-
ference persist, contact your dealer.

Specifications

Power source (20") AC 220~240V C.A. 50Hz
(15") Input: 100V-240V ~ 1.2A Max.50/60Hz
T elevision system System I
Colour system P AL/NTSC (in mode AV)
Channel coverage UHF:21-69
CATV:X,Y ,Z,S1-S41, B-Q
Aerial input impedance 75 ohm
AV T erminal
AV1: CENELEC Standard.
Input: Composite video, S-VHS, RGB and audio-L/R.
Output: TV-output with composite video and audio-L/R.
AV2:
RCA jacks.
Input: Composite video and audio-L/R.
Headphone socket
Sound output
Picture panel (inches)
Dimensions WxHxD(mm)
(with stand base)
Dimensions WxHxD(mm)
(without stand base)
Weight (kg) (w/stand)
Picture resolution
Viewing angles
Contrast ratio
Brightness
Response time
Due to SANYO's continuous improvement of quality policy, these data can
change without previous notice.
__
Output:12V - - - 3.4A
Stereo jack 3mm
CE15LC4-B CE20LC4-B
2x2W (RMS) 2x2W (RMS)
38cm./15" 51cm./20"
470x337x191 590x430,5x191
470x299x88 590x393,7x87,5
4,4 7
XGA 1024 (Horiz.) VGA 640 (Horiz.)
768 (Vert.) píxeles 480 (Vert.) píxeles
Horiz. 120° Horiz. 160°
Vert. 100° Vert. 140°
500:1 500:1
500cd/m2 500cd/m2
10 ms. 16 ms.
8