MA-Series Service Manual
Cams
CAMs for Falcon Cylinders
The Falcon MA Series requires a different CAM for keyed functions than its predecessor, the Falcon M Series. For all keyed
functions except the MA381 function, the MA Series uses a single CAM for all standard mortise cylinders and a single CAM for all
interchangeable core mortise cylinders. The chart below lists the CAM required.
Door
CAM Part
Handing
Number
ALL
5622-STD (F1)
ALL
5622-IC (F2)
The new Falcon MA Series MA381 function uses unique CAMs to operate
the lock. Different CAMs are required, depending on the handing of the lock.
The charts on the next page indicate which CAMs are to be used for each
configuration.
Outside
MA371, MA411, MA431,
MA441, MA451, MA521,
MA531, MA541, MA551,
MA561, MA571, MA581,
MA621, MA641, MA851,
MA881, MA911, MA921,
MA931, MA941
MA371, MA411, MA431,
MA441, MA451, MA521,
MA531, MA541, MA551,
MA561, MA571, MA581,
MA621, MA641, MA851,
MA881, MA911, MA921,
MA931, MA941
Inside
MA371, MA411, MA431,
MA441, MA931
MA371, MA411, MA431,
MA441, MA931
5622
Cams
For Cylinder
STANDARD CYLINDER
INTERCHANGEABLE
CORE
5622-IC
37