Selecting An Xm Channel Directly; Switching The Xm Display; Storing And Recalling Broadcast Stations - Pioneer DEH-P6000UB Operation Manual

Section
06 Available accessories
1
5
1 XM band indicator
2 XM channel number indicator
3 XM preset number indicator
4 XM channel select setting indicator
Shows what channel select setting has been
selected. CH is displayed when
Channel number is selected, and CAT is dis-
played when Category is selected.
5 XM text information
Shows the text information of broadcast
channel.
% Select an XM band.
Press BAND.
# Band can be selected from XM-1, XM-2 or
XM-3.
% Select a channel.
Push MULTI-CONTROL left or right.
# If you push and hold MULTI-CONTROL left or
right, you can increase or decrease channel num-
ber continuously.
# You can also perform tuning from a desired
channel category. (Refer to Selecting a channel in
the channel category on the next page.)

Selecting an XM channel directly

When using the remote control, you can select
the XM channel directly by entering the de-
sired channel number.
1 Press DIRECT.
Channel number input display appears.
2 Press 0 to 9 buttons to enter the desired
channel number.
# You can cancel the input number by pressing
CLEAR.
50
En
2 3 4
3 Press DIRECT.
The XM channel of entered number is
selected.
# After entering the number input mode, if you
do not perform an operation within about eight
seconds, the mode is automatically canceled.

Switching the XM display

% Press DISP to switch the XM display.
# You can scroll the text information to the left
by pressing and holding DISP.
Storing and recalling broadcast
stations
You can easily store up to six broadcast sta-
tions for later recall.
! Six stations for each band can be stored in
memory.
1 Press LIST.
Preset screen is displayed.
2 Use MULTI-CONTROL to store the se-
lected station in memory.
Turn to change the preset number. Press and
hold to store.
The XM preset number you have selected will
flash and then remain lit. The selected station
has been stored in memory.
3 Use MULTI-CONTROL to select the de-
sired station.
Turn to change the station; press to select.
# You can also change the station by pushing
MULTI-CONTROL up or down.
# If you do not operate the list within about 30
seconds, the display is automatically returned to
the ordinary display.