Using Your Remote Control; Using The 2 Way Remote Control For The First Time; Arming The Security System; Bypassing The Shock Sensor - Code Alarm Procomp Owner's Manual

Using Your Remote Control

Using the 2 Way Remote Control for the First Time.

The 2 way remote control has been shipped in Battery Save Mode to conserve
battery power and will be necessary for you to turn off battery save mode before
using the remote for normal operation. It is also recommended that you fully charge
the battery before use. Refer to the additional 2 way remote control features
section of this manual for details.

Arming the Security System

To arm the system, exit the vehicle, close all doors, then press the
parking lights will flash 2 times, indicating the system is armed, has locked the
doors (if equipped and connected) and activated the starter disable feature. The
LED status indicator will blink steadily, once per second.
NOTE: The system is defaulted with Silent Choice enabled, which requires a
second press of the
vehicle.

Bypassing The Shock Sensor

There are 3 additional modes of operation in which your system will react to the
shock sensor, FULL TRIGGER ONLY, ALL OFF, or CITY MODE.
Standard Shock - Press
be fully active.
Full Trigger Only - Pressing
system to Full Trigger Only in which the system will ignore the light touch
setting.
All Off - Pressing
All Off. In this mode the system will not react to the shock sensor and
the 2 way LCD remote will display the shock sensor icon.
City Mode - Pressing
to City Mode. In this mode the light touch horn output is extended to a full
10 seconds and full trigger horn output is shortened to 15 seconds, no icon
is displayed.
NOTE: The system will only change the shock sensor setting for one arm cycle
and will be defaulted back to normal operation the next time the system is armed.
*Throughout this manual, 'press' refers to pressing for less than 1 second; 'press and hold' refers to pressing for more
than 2 seconds.
2012 Audiovox Electronics Corporation. All rights reserved.
button to activate an audible arming response from the
once to arm the system, the shock sensor will
&
& again within 5 seconds will set the system to
& again within 5 seconds will set the system
together within 5 seconds will set the
button. The
3