Cisco UCS C24 Installation And Service Manual page 24

Installing the Server In a Rack
Figure 2-3
1
2
1 Front-left rack post
2 Front mounting pegs
3 Slide-rail assembly
d. Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail
assemblies are level and at the same height with each other.
e. Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops
and lock in place.
Step 3 Insert the server into the slide rails:
Note
a. Align the inner rails that are attached to the server sides with the front ends of the empty slide rails.
b. Push the server into the slide rails until it stops at the internal stops.
c. Push in the plastic release clip on each inner rail (labelled PUSH), and then continue pushing the
server into the rack until its front latches engage the rack posts.
Step 4 Attach the (optional) cable management arm (CMA) to the rear of the slide rails:
Note
Slide the plastic clip on the inner CMA arm over the flange on the mounting bracket that attached
a.
to the side of the server. See
Note
Slide the plastic clip on the outer CMA arm over the flange on the slide rail. See
b.
Cisco UCS C24 Server Installation and Service Guide
2-6
Attaching a Slide-Rail Assembly
The inner rails are pre-attached to the sides of the server at the factory. You can order
replacement inner rails if these are damaged or lost (Cisco PID UCSC-RAIL1-I).
The CMA is designed for mounting on either the right or left slide rails. These instructions
describe an installation to the rear of the right slide rails, as viewed from the rear of server.
Figure
Whether you are mounting the CMA to the left or right slide rails, be sure to orient the engraved
marking, "UP" so that it is always on the upper side of the CMA. See
3
4 Length-adjustment bracket
5 Rear mounting pegs
6 Rear securing latch
2-4.
Chapter 2 Installing the Server
5
6
4
Figure 2-4.
Figure 2-4.
OL-26647-01