Cisco UCS C24 Installation And Service Manual page 66

Installing or Replacing Server Components
Caution Make sure that the circuit board connector of the riser is aligned correctly with the motherboard socket
before you push down to seat the riser in the next step.
Carefully push down on both ends of the PCIe riser to fully engage its circuit board connector with
c.
the socket on the motherboard.
Reconnect cables to any PCIe cards installed in the riser.
d.
Replace the top cover.
e.
f. Replace the server in the rack, replace cables, and then power on the server by pressing the Power
button.
Figure 3-19
1 PCIe riser 1 alignment point locations (three) 2
Cisco UCS C24 Server Installation and Service Guide
3-30
Replacing the PCIe Riser
SYS FAN1
SYS FAN2
Port 1
SYS FAN3
SYS FAN4
Port 0
Chapter 3
1
PCIe riser 1
CPU 1
PCIe riser 2
CPU 2
PSU 1 (bottom)
PSU 2 (top)
PCIe riser 2 alignment point locations (two)
Maintaining the Server
1
2
OL-26647-01