Table of Contents
Advertisement
Using Universal Home Remote
Press and hold the appropriate button for at least half of
a second. The indicator light will come on while the
signal is being transmitted.
Reprogramming Universal Home
Remote Buttons
Any of the three buttons can be reprogrammed by
repeating the instructions.
Erasing Universal Home Remote
Buttons
The programmed buttons should be erased when the
vehicle is sold or the lease ends.
To erase either Rolling Code or Fixed Code on the
Universal Home Remote device:
1. Press and hold the two outside buttons at the same
time for approximately 20 seconds, until the
indicator lights, located directly above the buttons,
begin to blink rapidly.
2. Once the indicator lights begin to blink, release both
buttons. The codes from all buttons will be erased.
For help or information on the Universal Home Remote
System, call the customer assistance phone number
under Customer Assistance Offices on page 8-6.
Storage Areas
Glove Box
Pull the handle up to open.
Cupholders
Removable cupholders are located in front of the center
console. See "Center Console Storage Area" following
for how to access them. Press and hold the tab at
the rear of the cupholders and lift up and rearward to
remove the cupholders. This will disengage the two
forward tabs.
To reinstall them, place the two forward tabs into the
slots and push the rear of the cupholder down.
For vehicles with rear seat cupholders, pull down the
door on the back of the center console to access them.
3-45
Advertisement
Chapters
Table of Contents
