Bluetooth Pairing - Promate proHarmony.2 User Manual

Introduction to Bluetooth™ Equipment's Pairing
1. First step
Shutdown status: Press and hold S4 key for 5 seconds → red & blue lights will
start flashing quickly → headset will then tune a "dee" sound → red light
flashes once →red & blue lights start flashing alternately → headset tunes out
a "beep, beep " sound → release S4 key → enter into pairing status.
2. Second step
Begin pairing to your smartphone (Please refer to smartphone user manual).
After searching for devices you will find "proharmony.2" in your smartphone
equipment list.
3 Third step
You will be required to enter a Pin-Code → Password 0000 is needed to enter→
Pairing successful.
(Note: 0000 is a default pairing Pin-Code for proHarmony.2)
4 Fourth step
Pairing successful → headset tunes a "beep, beep" sound → red & blue lights
flash slowly, single & stereo are connected successfully.
*Only red light flashes slowly → single connected successfully.
*Only blue light flashes slowly →stereo connected successfully.
Note: If proHarmony.2 cannot recognize a pairing device within 3 minutes, it
automatically shuts down. If headset is not in a pairing mode, your smartphone and
other Bluetooth™ devices will not be able to find the headset. Please set the device's
pairing mode on. It can then be recognized and used with other devices.