Use Of The Appliance - Electrolux ESL 67040 User Manual

6 electrolux
ENERGY SAVER BUTTON
This function decreases the temperature in
the drying phase. The power consumption
decreases by 25%. The dishes can be wet
at the end of the program when you open
the appliance door. We recommend that
you keep the door ajar and let the dishes
dry.
Press this button to activate the function.
The related indicator comes on.
The function can be activated with all wash-
ing programs but has effect only on some
programs. To see where the energy saver
function has effect, refer to the 'Washing
programs' chart.
MULTITAB BUTTON
Press this button to activate or deactivate
the multitab function. Refer to 'Multitab
function'.
RESET BUTTON
Press this button to cancel a washing pro-
gram in operation. Refer to 'Setting and
starting a washing program'.
SETTING MODE
The appliance must be in setting mode
for these operations:
• To set and start a washing program.
• To set and start a delay start.
• To adjust electronically the level of the
water softener.
• To activate or deactivate the rinse aid
dispenser (only with the multitab function
on).
• To deactivate or activate the acoustic
signals.
Switch on the appliance. The appliance
is in setting mode when:
• The display shows two horizontal status
bars.

USE OF THE APPLIANCE

Refer to the specific instructions for
each step of the procedure.
1. Check if the water softener level is cor-
rect for the water hardness in your area.
If necessary set the water softener.
2. Fill the salt container with dishwasher
salt.
3. Fill the rinse aid dispenser with rinse aid.
Switch on the appliance. The appliance
is not in setting mode when:
• The display shows the time of the wash-
ing program or of the delay start.
– To go back to the setting mode, it is
necessary to cancel the program or
the delay start. Refer to 'Setting and
starting a washing program'.
ACOUSTIC SIGNALS
You can hear the acoustic signals when:
• The washing program is completed.
• You adjust electronically the level of the
water softener.
• The appliance has a malfunction.
Factory setting: acoustic signals active.
Deactivating the acoustic signals
1. Switch on the appliance. Make sure that
the appliance is in setting mode.
2. Press and hold button (4) and button (5)
at the same time until the indicators of
buttons (3), (4) and (5) flash.
3. Release button (4) and button (5).
4. Press button (5),
• The indicators of button (3) and but-
ton (4) go off.
• The indicator of button (5) continues
to flash.
• The display shows the setting of the
acoustic signals.
5. Press button (5) to change the setting.
The display shows the new adjustment.
6. Switch off the appliance to confirm.
To activate the acoustic signals again, do
steps (1) through (6).
4. Load cutlery and dishes into the appli-
ance.
5. Set the correct washing program for the
type of load and soil.
6. Fill the detergent dispenser with the cor-
rect quantity of detergent.
7. Start the washing program.
Acoustic signals
activated.
Acoustic signals
deactivated.