Prosharp AS 2001 Original Instructions Manual page 10

Grinding
.
1. After dressing your grinding wheel, measure your skate and set the scale knob
on the same width as your skates.
2. Clamp the skate in to the skate-holder. The toe of your skate should always point
to your left
3. Choose number of grinding cycles by using the "SHARP" button. 1 push is worth
of 1 cycle, 2 pushes is worth of 2 cycles and so on. Machine will start after
choosing the amount of cycles and will stop automatically once finished.
4. If you want to stop the grinding earlier (during cycles 2-5) just push the "SHARP"
again. During 1 cycle push the button and the skateholder will turn back. Push
again and it will turn back again.
Notice: The amount of cycles required to sharpen your skates varies depending
of the quality and condition of your skates.
For more detailed instructions how to use the electronics and adjustments please
take a look at our Instructional Videos at www.prosharp.com
page 10