Troubleshooting; Product Maintenance; Limited Warranty - HAMPTON BAY SKU 939-473 Instruction Manual

TROUBLE SHOOTING:
Problem
Light Bulb will
illuminate.
Fuse blows or
breaker trips when light
bulb is illuminated.

PRODUCT MAINTENANCE:

1. To clean the outside of the fixture turn the power off to the fixture, use a clean, dry,
or slightly dampened cloth and wipe the shades and the exterior surfaces of the
fixture.
2. To clean the inside of the fixture, first disconnect power to the fixture by turning
off the circuit breaker or by removing the fuse at the fuse box. Next, use a clean,
dry, or slightly dampened cloth and wipe the inside glass and interior surfaces of
the fixture.
3. Allow the fixture to thoroughly dry before restoring power to the fixture.
CAUTION: Do not use any cleaners with chemicals, solvents or harsh abrasives as
damage to components or finish may occur.
The manufacturer warrants this lighting fixture to be free from defects in materials and
workmanship for a period of five (5) years from date of purchase. This warranty applies
only to the original consumer purchaser and only to products used in normal use and
service. If this product is found to be defective, the manufacturer's only obligation, and
your exclusive remedy, is the repair or replacement of the product at the manufacturer's
discretion, provided that the product has not been damaged through misuse, abuse,
accident, modifications, alterations, neglect or mishandling. This warranty shall not
apply to any product that is found to have been improperly installed, set-up, or used in
any way not in accordance with the instructions supplied with the product. This
warranty shall not apply to a failure of the product as a result of an accident, misuse,
abuse, negligence, alteration, or faulty installation, or any other failure not relating to
faulty material or workmanship. This warranty shall not apply to the finish on any
portion of the product, such as surface and/or weathering, as this is considered normal
wear and tear. The manufacturer does not warrant and specially disclaims any warranty,
whether express or implied, of fitness for a particular purpose, other than the warranty
contained herein. The manufacturer specifically disclaims any liability and shall not be
liable for any consequential or incidental loss or damage, including but not limited to
any labor/expense costs involved in the replacement or repair of said product.
Possible Cause
not 1. Light bulb is burned
out.
2. Power is off.
3. Faulty wire connection.
4. Faulty switch.
circuit Crossed wires or power
wire is grounding out.

LIMITED WARRANTY

Corrective Action
1. Replace light bulb.
2. Make sure power supply is
on.
3. Check wiring.
4. Test or replace switch.
Check wire connections.
4