Assembly Diagram - HAMPTON BAY SKU 939-473 Instruction Manual

tube. Install the diffuser and tighten with decorative cap. Note: The hex nut can be
adjusted up and down as needed.
6. Remove the mounting bracket assembly from the canopy and install mounting
bracket to existing outlet box with outlet box screws provided.
7. Make the electrical connections (Required Supply Circuit: 120V 60Hz):
a. Connect the neutral/white wire from the fixture to the neutral/white wire from the
Outlet Box.
b. Connect the live/black wire from the fixture to the live/black wire from the Outlet
Box.
c. Connect the ground wire from the fixture to the ground wire from the Outlet Box.
d. Secure the connections using the wire connectors. Wrap the wire connections with
electrical tape to secure the connections.
e. Place the wires back inside the outlet box.
8. Secure the canopy to the mounting bracket with the canopy screws.
RELAMPING THE LIGHT BULB(S)
1. Turn off the power to the light fixture.
2. Remove the old light bulb(s) and install the new light bulb(s).
3. Restore power to the light fixture.
CAUTION: Refer to the re-lamping label located on the fixture. Do not exceed
recommended wattage.

ASSEMBLY DIAGRAM

1. Outlet box
2. Wire connector
3. Ground (bare) wire
4. Neutral (White) wire
5. Live (Black) wire
6. Ground screw
7. Mounting bracket
8. Outlet box screw
9. Canopy screw
10. Canopy
11. Straight tube
12. Fabric shade
13. Thread tube
14. Bulb (sold separately)
15. Hex nut
16. Flat washer
17. Plastic washer
18. Diffuser
19. Decorative cap
1
2
6
7
14
15
3
5
4
3
8
9
10
11
12
13
16
17
18
19