Installing External Drives - Acard AEC-67160 Ultra160 User Manual

Step 3: Find out pin 1 of the connector on your device.
Step 4: Select one available connector on the cable, then plug it into your internal
device connector aligning with pin-1 to pin-1.
Step 5: If you have two or more devices, please repeat Step 2 and Step 3 to install
you remaining devices.
Step 6: Please set the last SCSI device terminator on.
Note: For terminating your internal SCSI device, please refer to
your original SCSI device supplier or manufacture.
Step 7: Identify your devices ID number, that is, you have to set all your internal
SCSI devices an unique ID number to avoid hardware conflict.

2.3 Installing External Drives

Power Connection
For external SCSI devices, you need to connect the power core to turn on your
external device.
Cable Connection
There are two different ways to make external cable connection when connecting to
only one device or connecting to more than one devices.
1. Connecting to only one device
Step 1: Identify number of pins on the connectors, either adapter or device. Then,
prepare an external cable whose connectors match your need, e.g. 50-pin
to 50-pin, 68-pin to 68-pin, or 68-pin to 50-pin.
Step 2: Plug one end of the high-density external SCSI cable into the host adapter
connector.
Step 3: Plug the other end of this SCSI cable into one connector on the SCSI
device that you wish to connect.
Step 4: Enable the terminator on device.
AEC-67160 Ultra160 SCSI Adapter
8