Windows 2000 Environment - Acard AEC-67160 Ultra160 User Manual

AEC-67160 Ultra160 SCSI Adapter

4.2.3 Windows 2000 Environment

Driver installation is required when it is the First Time to Setup
Windows 2000 into the System
AEC67160.SYS is designed for Microsoft Windows 2000 miniport
drivers. It allows driver connects to SCSI devices (which is
supported by Microsoft)
1.Insert Windows 2000 boot disk and boot from floppy disk.
(If boot from CD-ROM or install from hard disk, please press
"F6" for the first booting screen)
2.Follow the Windows 2000 setup procedures.
3.Press "S" to skip mass storage devices detection.
4.Press "S" to specify additional SCSI adapter.
5.Move the highlight bar to "the other" and press "Enter".
6.Please insert the AEC-67160 DISK into floppy drive A.
7.Hightlight the "ACARD Miniport driver". Press "Enter" to
proceed.
8. Windows 2000 should now recognize the ACARD Miniport driver
and the SCSI hardware. Then Please follow the Microsoft
Windows 2000 installation.
9.Setup program will ask to insert driver disk, please insert DISK
into floppy drive A.
Install Driver for Windows 2000
When Windows 2000 had been installed and you wish to plug the
ACARD SCSI device on the Windows 2000 system, please follow
the ADD SCSI Controller instructions which states at below.
29