Planet WGSW-24040 User Manual page 77

The page includes the following fields:
Object
•
Port
•
Link
•
Current Link Speed
•
Configured Link Speed
•
Flow Control
• Maximum Frame
• Excessive Collision
Mode
• Power Control
Description
This is the logical port number for this row.
The current link state is displayed graphically. Green indicates the link is up and
red that it is down.
Provides the current link speed of the port.
Select any available link speed for the given switch port. Draw the menu bar to
select the mode.
• Auto Speed - Setup Auto negotiation.
• 10 half
- Force sets 10Mbps/Half-Duplex mode.
• 10 Full
- Force sets 10Mbps/Full-Duplex mode.
• 100 half
- Force sets 100Mbps/Half-Duplex mode.
• 100 full
- Force sets 100Mbps/Full-Duplex mode.
• 1000 full
- Force sets 10000Mbps/Full-Duplex mode.
• Disable
- Shutdown the port manually.
When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used.
• Current Rx column indicates whether pause frames on the port are
obeyed.
• Current Tx column indicates whether pause frames on the port are
transmitted.
The Rx and Tx settings are determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control.
This setting is related to the setting for Configured Link Speed.
Enter the maximum frame size allowed for the switch port, including FCS. The
allowed range is 1518 bytes to 9600 bytes.
Configure port transmit collision behavior.
• Discard: Discard frame after 16 collisions (default).
• estart: Restart backoff algorithm after 16 collisions.
The Usage column shows the current percentage of the power consumption per
port. The Configured column allows for changing the power savings mode
parameters per port.
• Disabled: All power savings mechanisms disabled.
• ActiPHY: Link down power savings enabled.
• Dynamic: Link up power savings enabled.
77
User's Manual of WGSW-24040 / WGSW-24040R
SGSW-24040 / SGSW-24040R