Removing Or Replacing The Switch - IBM FC5022 User Manual

2
Managing the switch

Removing or replacing the switch

1. Before removing a switch from the chassis, read the following safety information:
2. Disconnect any cables from the switch that you are removing. For additional information about
3. Pull the release latches out from the switch, as shown in
4. Slide the switch out of the bay and set it aside.
5. Replace the removed switch with either another switch or a filler panel. You must complete this
6. If you installed another switch in the bay, reconnect the cables that you disconnected in
7.
8. Establish a connection to the CMM. For more information, see the following sections:
36
•
"Safety" on page vii
•
"System reliability guidelines"
disconnecting cables, see
documentation that comes with the cables and optional network devices to which the cables
have been connected. For the locations of the connectors on the chassis, see the
documentation that comes with the chassis.
moves out of the bay approximately 0.6 cm (0.25 inch).
step within 60 seconds.
Attach any additional cables that are required by the switch. For additional information about
connecting cables, see "Installing and removing an SFP+ transceiver"
documentation that comes with the cables and optional network devices to which the cables
have been connected. For the locations of the connectors on the chassis, see the
documentation that comes with the chassis.
Install SFP+ transceivers and dust caps where appropriate. For safety information and
instructions, see the following sections:
•
"Installing and removing an SFP+ transceiver"
•
"Using dust caps" on page 19
•
"Connecting to the switch over SSH"
•
"Connecting to the switch using Web Tools"
on page 11
"Installing and removing an SFP+ transceiver"
on page 16
on page 27.
on page 28
IBM Flex System FC5022 16Gb SAN Scalable Switch User's Guide
on page 16, and the
Figure 3 on page 2-14. The switch
on page 16, and the
step 2.