Assembly - CEL 18v Li-Ion User Manual

Assembly

To fit or replace the auto line feed. Press in the rippled buttons
on both sides of the feed cap and remove (do not force the
cap). Lift out any empty feed spools, remove any debris and
replace with a new CEL line spool LT1-SP01. If necessary
wind any excess line in the direction indicated on the spool
(the spool should unwind in an anticlockwise direction). Pass
some line through the Feed Hole and place the spool into the
holder so the teeth on the spool contact with the triangle teeth
in the trimmer. Pull the line to take up any slack, replace the
feed cap, pressing the buttons in so that it locks into place.
Additional line can be fed in increments by pressing the feed button and pulling the line. Line
will be fed each time the trimmer is started and cut to length by the line blade.
BEFORE STARTING THE TRIMMER YOU MUST FIT THE
SAFETY GUARD!
To fit the guard, align the guard over the head of the trimmer
taking note of the notch to aid alignment. Using a cross head
screwdriver, fit the 3 screws provided. NOTE, check and
Notch
tighten these screws regularly.
(Optional for guiding head while cutting edges)
To fit the Edging wheel, remove the thumb screw and align the
wheel mount to the rectangular extrusion just above the
trimmer head, fasten in place with the thumbscrew.
3.0
Feed Hole