Adjustments - CEL 18v Li-Ion User Manual

Adjustments

Always disconnect the battery and ensure the motor has stopped before cleaning or making
any adjustments.
Always wear protective equipment when operating power tools.
Adjust the 12" Extension to suite your needs. Twist the collar in this direction to unlock then
slide the lower shaft to the required length. Twist the collar back and tighten before operating
the trimmer.
Adjust head pivot so that the cutting line spins at around
30° to the ground. This will maximise cutting efficiency
and safety measures. Press the locking button in and
rotate to a suitable position. Make sure the button springs
out again and the head is locked before operating the
trimmer. Using the head pivot the cutting line can be
adjusted to be parallel to the handle allowing reach under
low objects.
When Cutting against walls and other hard objects use
the Edging Guide to ensure the line does not contact.
Adjust the Control Handle to a comfortable operating
position. Press the 2 locking buttons in and rotate to the
desired angle. Make sure the buttons spring back out to
ensure the handle is locked in place.
Adjust head rotation angle to trim edges. Twist the 90º
Rotation Collar this way to unlock then turn the head to
the desired orientation. Twist the collar back and tighten
before operating the trimmer. You may also wish to
connect the Edging Wheel to guide the trimmer.
7.0