Honeywell Tuxedo Touch User Manual page 33

Calibration Test
ICON
1. Select the Calibration icon and using a
stylus, follow the screen directions by
pressing a series of crosshairs (+) and
boxes (❏ ❏ ❏ ❏ ) on the screen until done.
2. If the test was successful, press OK; the
screen returns to the Keypad Test screen.
Keypad Reset
To access Keypad Reset press Setup and the System Setup icon and then do the following:
ICON
1. Press the Advanced Setup icon.
2. Enter your Authorized Code.
3. Press the Keypad Reset icon.
Night Setup
To set the NIGHT function, press the System Setup and Advanced Setup icon and then do the following:
ICON
1. Enter your Authorized Code, if required.
2. Press the Night Setup icon.
3. Select the arming mode to be activated when
NIGHT is selected on the "Arming" screen.
Output Setup Function
The Output Setup function allows you to disable Output selection. There are a maximum of 18 outputs that can be enabled or
disabled. To set the Output Setup function, press the System Setup and Advanced Setup icon and then do the following:
ICON
1. Enter your Authorized Code, if required.
2. Press the Output Setup icon.
3. Highlight the Output selection on the screen
and press the Disable or Enable button to
change the setting.
4. Press Apply.
Output Setup Icons
Apply
OK
User System Setup (cont'd)
ACTION
A pop-up message displays:
If the Calibration test was successful, a confirmation screen appears stating:
"Congratulations Calibration Success"
If the test was unsuccessful, an error message appears stating: "Calibration
failed, do you want to retry?" Yes or No.
ACTION
ACTION
ACTION
Back
Home
NOTES
Touch screen calibration
Touch crosshair to calibrate
NOTES
When the Keypad Reset icon is pressed, the message is displayed:
Confirmation
Are you sure you want to reset?
Select Yes or No.
NOTES
Apply accepts the setting.
Back cancels your selection.
NOTES
This is a local setting for the graphic keypad. If user has the maximum
number of keypads on the system, and wants to disable the same output for
all, each keypad needs to be set individually.
A confirmation window is displayed stating:
"Information
Settings saved"
.
Press OK to save the setting
If the Back icon is pressed, a confirmation window appears stating:
"Output Settings changed. Do you want to save new settings?"
Select Yes or No.
33