Sirius XM RAdio Onyx User Manual page 34

Vehicle Installation
• Convertible:
1. Bring the antenna cable from the antenna into the trunk at the front
edge of the trunk lid. Keep any bends in the cable loose. Tape or
tie the cable along the inside of the trunk lid to the trunk lid hinge
strut.
2. Allow enough slack in the cable so the trunk lid can easily open and
close and keep the cable away from hinges, gears, etc., that could
crimp or cut it. Route the cable along the trunk wall and into the
cabin through a conduit or along an existing wiring harness.
3. Route the cable through the main cabin area under the interior
trim, towards the front of the vehicle. Use a blunt plastic putty
knife or similar blunt tool to lift the plastic trim just enough to
tuck the cable under underneath. Avoid side airbag locations on
back pillars and above the doors. Airbag locations are marked with
"SRS" logos. Be careful not to crimp or cut the cable.
4. Bring the cable out from the trim near the front of the cabin
and route it under the carpet
toward the dashboard or
console. Coil any excess cable
in a hidden location, such as
under the carpet, keeping it
away from any vehicle pedals
or controls. Secure the excess
cable with wire ties (purchased
separately).
5. Bring the end of the cable
out at the PowerConnect
Vehicle Dock location. Leave
yourself enough cable so you can easily connect it to the antenna
34