Jumper Settings; Table 2 Jumper List; Table 3 Jp1, Clear Cmos Selection; Table 4 Jp2, 7, 13, 14 And Com Port Signal/Power Selection - Quanmax KUBE-8040 User Manual

Jumper Settings

To ensure correct system configuration, the following section describes how to set
the jumpers to enable/disable or change functions. For jumper descriptions, please
refer to the table below
Table 4 JP13, JP14, JP7, JP2, COM1, 2, 3, 4 Port Signal / Power Selection
JP2,JP7,JP13,JP14 : Pitch:2.54mm [YIMTEX 3322*05SAGR(6T] LEAD FREE
KUBE-8040 User's Manual
.

Table 2 Jumper List

Label
JP1 Clear CMOS Selection
JP13 COM1 Signal / Power Selection
JP14 COM2 Signal / Power Selection
JP7 COM3 Signal / Power Selection
JP2 COM4 Signal / Power Selection
JP15 MPCIE Rev select

Table 3 JP1, Clear CMOS Selection

Jumper
Open
Short
Pitch: 2.54mm [YIMTEX 3321*02SAGR(6T)]
Jumper Setting
1-3 Short
3-5 Short
1
5-7 Short
7-9 Short
2-4 Short
4-6 Short
2
6-8 Short
8-10 Short
Function
Status
Normal Operation (default)
Clear CMOS
Pin 1 = +12V
Pin 1 = DCD@RS232, TX-@RS422,
DATA-@RS485(Half Duplex) (default)
Pin 9 = +12V
Pin 9 = RI (default)
23
Function
Pin 1 = +5V
Pin 1 = +5V
Pin 9 = +5V
Pin 9 = +5V