Table of Contents
Advertisement
Password column by default is blank and 'Enter Password' button can be used to enter it.
To set the Password of the device (required when creating a private network), first select the
device by clicking on its name in the lower panel and then click on the Enter Password button. A
dialog box will appear as shown in Figure 1-3 to type the password. The selected device name is
shown above the password field and the password can be verified by hitting the OK button. The
Password field accepts the Device password in any case formats, with or without dashed between
them. If a device was not found, the user will be notified along with the suggestions to resolve
common problems. This process might take a few seconds to get completed.
Figure 1-3: Set Device Password
Add button is used to add a remote device to the existing network by entering the device password
of the device. A dialog box will appear as shown below in Figure 1-4. The dialog box allows the
user to enter both a device name and the password. If a device was not found, the user will be
notified and suggestions to resolve common problems will be presented.
31
Advertisement
Table of Contents
