Amer.com SD5 User Manual

SD5 5-Port Dual-Speed Mini
Switch
User's Guide
Version 1.0
P/N: ATISD5030314
This User's Guide contains important information
regarding the installation of your switch. Please read it
completely before beginning installation.
For future reference, record the serial number
of your network switch in the space below:
SERIAL number
The serial number is located on the bottom of the switch.
Amer.com
7259 Bryan Dairy Road, Largo, FL 33777
© Amer.com Corp., 1997-2002 All rights reserved.
No part of this publication may be reproduced in any
form or by any means or used to make any derivative
such as translation, transformation, or adaptation
without permission from Amer.com, as stipulated by the
United States Copyright Act of 1976.
Amer.com reserves the right to make changes to this
document and the products which it describes without
notice. Amer.com shall not be liable for technical or
editorial errors or omissions made herein; nor for
incidental or consequential damages resulting from the
furnishing, performance, or use of this material.
Amer.com is a registered trademark of Amer.com. All
other trademarks and trade names are properties of
their owners.
FCC Class B Certification Statement
Model SD5 FCC Class B
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired
operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If the equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected to.
• Consult the dealer or an experienced radio/TV
technician for help.
Shielded interface cables must be used in order to
comply with emission limits. You are cautioned that
changes or modifications not expressly approved by
the party responsible for compliance could void your
authority to operate the equipment. For more
information please contact the Federal Communication
Commission.
CE Mark Class B Statement In a domestic
environment, this product may cause radio interference
in which case the user may be required to take
adequate measures.