Install The Lower And Upper Vents - Norcold N611v Owner's Manual

Install the Lower and Upper Vents

1. Using the following chart, decide which vents and rough opening (RO) sizes to use:
Certified Vent
Upper Roof Exhaust Cap
Upper Roof Exhaust Vent
Lower Metal Intake
Upper Exhaust & Lower Intake Plastic-large
Upper Exhaust & Lower Intake Plastic-small
2. Install the lower intake vent (See Art01598, Art01599, and Art01602):
The lower intake vent is also the service access opening for the components
NOTICE
on the rear of the refrigerator.
Make sure the bottom of the opening of the lower intake vent is
!
even with or immediately below the floor level. This allows any
WARNING
leaking propane gas to escape to the outside and not to collect at
floor level.
- Make sure the bottom of the opening of the lower intake vent [9] is even with or
immediately below the floor level.
- When using either 616010 or 621156 vent, align the lower intake vent vertically below the
coils [10] and the condenser [11] of the refrigerator.
- When using either 620505 or 636264 vent, either:
- Make sure that the centerline [297] of the vent rough opening [295] is 1 1/2 inch to
the right of the enclosure centerline [296] (See Art02424).
OR
- Make sure that the right-hand edge of the vent rough opening [295] is 1 3/8 inch
[299] from the inside wall of the enclosure (See Art02424).
Installation and Owner's Manual 14
P/N
622293
616319
616010
621156
620505, 636264
RO Height
N/A
24 in.
13 5/8 in.
13 3/4 in.
6 3/16 in.
296
Art02424
298
RO Width
N/A
5 1/4 in.
21 5/8 in.
21 1/2 in.
17 3/16 in.
11
10
9
Art01602
297
295
299