Norcold N611v Owner's Manual page 18

- Make sure that the bend of the baffle is the full
width of the inside of the enclosure.
- Make sure that the bend of the baffle is flush with
the bottom edge of the upper intake vent door
frame.
- Make sure that the top edge of the baffle is
between 1/4 inch [213] below the condenser and
1 1/2 inches above the bottom of the condenser
and that there is 1/4 inch or less clearance [15]
between the rear of the condenser and the baffle.
- For the best cooling performance, the baffle
should be 1/4 inch below the bottom of the
condenser.
- If the depth of the enclosure is more than 26 inches
[27], install a wood or an aluminum or galvanized
steel sheet solid box baffle [21] between the lower
intake vent and the upper exhaust vent (See
Art01593-1).
- Make sure that the solid box baffle is the full width
of the inside of the enclosure.
- Make sure that the bottom of the solid box baffle
is 18 inches to 18 1/2 inches above the bottom of
the enclosure [17].
- Make sure that the back of the solid box baffle is
perpendicular to the bottom of the enclosure.
- Make sure that the horizontal top of the solid box
baffle is even with the bottom edge of the upper
exhaust vent [24].
- Make sure that the vertical top edge of the baffle is
between 1/4 inch [213] below the condenser and 1 1/2
inches above the bottom of the condenser.
- Make sure that there is 1/4 inch or less clearance [15]
between the rear of the condenser and the baffle.
- When using an upper side-wall exhaust vent 620505 or 636264:
- If the depth of the enclosure is 24 inches or more and is
less than 25 inches [27], do not install a baffle.
- If the depth of the enclosure is 25 inches or more and is
less than 26 inches [27], install a baffle [16] to the rear of
the enclosure (See Art02425).
- Make sure that the baffle is the full width of the inside
of the enclosure.
Installation and Owner's Manual 18
15
13 15
25
10
27
13 15
15
25
10
27
11
15
24
213
21
17
9
Art01593-1
11
15
24
213
26
9
Art02425